Applying a Vinyl Decal Here are some simple steps toward applying a vinyl decal
- Designate the area you want to apply your decal. Measure the area and above it mark a straight, level line with masking tape to use as a guideline.
- Using the guideline, take your unpeeled vinyl decal and tape the top of it, following the masking tape, to the substrate.
- Invert the decal and tape up and out of the way. Clean the decal area with alcohol and water. After it is cleaned spray the area with a mixture of dishwashing liquid and water. Do not dry, off because the solution will allow you to move and adjust you decal.
- Remove the paper backing (not decal transfer tape) and place design down on the wet surface.
- Move decal around until it is in the proper position. With a small squeegee scrape over decal pushing out any excess water and air bubbles.
- Spray the transfer side of the design with solution to aid easy removal. Peel away transfer tape from design.
